Time And Date - Planet NVR-810 User Manual

If you wish to set the recorder to use a static IP address in your local area network,
1. Choose "Static IP" from the "Connection Type" drop-down menu
2. Enter the IP address, subnet mask, default gateway address and DNS server
address for the recorder
3. Enable "DHCP Server" under "DHCP Server" if you wish to use the recorder as a
DHCP server, or leave it disabled if there is already a DHCP server in the network
4. Click Apply for the settings to take effect.
The recorder can detect the presence of a DHCP server upon startup. It sets itself
to use static IP address if there is no DHCP server currently presented in the network.
Its DHCP server function is also turned on at the same time to assign IP addresses
to cameras that are later connected to the network. You can manually turn off the
DHCP server function if you wish to use a separate DHCP server.
Change the recorder's IP address would require the recorder to restart.
Restart the device under "system Options" >> "Maintenance" for the settings to take
effect.

6.1.2 Time and Date

Set the time and date by selecting the time zone according to your location. It is
imperative that you set the recorder's time correctly to avoid the following errors:
• Incorrect display time for playback videos.
• Inconsistent display time of event logs and when they actually occur.
After selecting the time zone, choose an option below to set the recorder time.
• Manual - Use the drop-down list and configure the time manually.
.