Component Leds; Booting An Omniswitch - Alcatel-Lucent OmniSwitch 6350 Hardware User's Manual

OmniSwitch 6350 Switches

Booting an OmniSwitch

The switch does not use an on/off switch. The power cord is the switch's only connect/disconnect device.
The power connector socket is located on the power supply rear panel. For more information, refer to
"OmniSwitch 6350 Chassis and Hardware Components" on page
To boot the switch, plug the power supply cord into an easily-accessible,
(Do not use extension
Note. For a few seconds, at the beginning of the boot up process, random characters may briefly display
on the console of an OS6350. This is due to an initial baud rate mismatch. As soon as the bootrom is
initialized, the issue is automatically resolved.

Component LEDs

During the boot process, component LEDs will flash and change color, indicating different stages of the boot.
Following a successful boot, chassis LEDs should display as follows:
OK1
PRI
PWR
Note. If the LEDs do not display as indicated, make sure the boot process is complete. If the LEDs do not
display as indicated following a complete boot sequence, contact Alcatel-Lucent Customer Support. For
information on LED states, refer to
For information on logging in and configuring your switch, refer to
OmniSwitch 6350 Hardware Users Guide
cords.) The switch will power on and boot automatically.
Solid Green
Solid Green
Solid Green
"Chassis Status LEDs" on page
September 2015
5 Booting
3-1.
properly grounded
3-19.
Chapter 2, "Getting Started."
power outlet.
page 5-1