Furuno TZT9 Installation Manual page 29

Menu Item
[Data Source]
[Sensor List]
[PGN Output]
[Sky View]
Menu item
[WAAS Mode] Select [ON] to use the WAAS mode.
[Heading Offset] Enter the offset value for heading.
[Pitch Offset] Enter the offset value for pitching.
[Roll Offset] Enter the offset value for rolling.
Menu item
[Heading] Offset heading data.
[Speed Through Calibrate speed data. Enter amount in percentage.
Water]
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50% to 50%
[Wind Angle] Offset wind angle data.
[Sea Surface Offset sea surface temperature data.
Temperature]
Menu item
[COG & SOG]
[Heading]
[Speed Through Water]
[Wind Speed & Angle]
[Rate of Turn]
Menu item
[FAX30 Browser]
[FA30 Browser]
[FA50 Browser]
Note: The [External Touch Screen Mode] allows you to facilitate the operation of the
TZT9/TZT14 when an external dual touch screen is connected to the MFD via the USB
and DVI-D ports. When the [External Touch Screen Mode] is set to [ON], the contex-
tual Rotokeys appear near the cursor and the dual gesture is set automatically to dis-
play the "Home" screen.
Description
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The Furuno products are shown at the upper part of the list.
Show the information for sensors connected to your equipment. Also,
you can set "Nickname" for them here.
Select [ON] for the PGNs (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
Show the condition of GPS and GEO (WAAS) satellites. Number, bear-
ing and elevation angle of all GPS and GEO satellites (if applicable) in
view of your receiver appear.
Menu Initial Setup (SC-30 Setup)
Description
Menu Initial Setup (Calibration)
Description
Menu Initial Setup (Data Damping)
Description
Set data damping time. The lower the set-
ting the faster the response to change.
Menu Initial Setup (Browser Installation)
Description
Show the Facsimile Receiver FAX-30 display.
Show the AIS Receiver FA-30 display.
Show the AIS Receiver FA-50 display.
3. SETTING UP THE EQUIPMENT
Options (setting range)
Options (setting range)
-180° to +180°
-180° to +180°
-180° to +180°
Options (setting range)
-180.0° to +180.0°
-50% to +50%
-180° to +180°
-10°C to +10 °C
Options (setting range)
0 to 59 seconds
Option (setting range)
3-7