Furuno TZT9 Installation Manual page 13

2.1.1 NETWORK port(s)
TZT9/14 (just like previous NavNets)
uses standard TCP/IP Ethernet to
share radar/sounder images and
other navigation information from de-
vices connected within the network system. In any single NavNet TZtouch network, a
combination of up to six TZT9/14 may be connected to each other. All NavNet TZ-
touch network components have integrated regular RJ45 Ethernet port(s), one on
TZT9 and three on TZT14. Connect MOD-WPAS0001-030+ cable (supplied).
2.1.2 MULTI port
Use the cable assembly FRUDD-
18AFFM-L180 (supplied, 2 m) for the
event switch, external buzzer, speed
alarm and the power for CAN bus.
This cable has an 18-pin connector. For example, a MOB contact closure input may
be connected to pin 15 and 11*.
*Note that any TZT9/14 interfaces to virtually any MOB system or event switch (point
save) contact closure signal using these pins.
Pin No. Color
18 Light green
17 Pink
16 Purple
15 White
14 Gray
13 Yellow
12 Black/White
11 Black
10 Blue/White
9 Blue
8 Green/White
7 Green
6 Orange/White
5 Orange
4 Brown/White
3 Brown
2 Red/White
1 Red
2 1
5
6 4
8
11 10 9
13
15
14 12
18
17 16
Function
NET-C IN (0V)
NET-S IN (+12V IN)
Shield
BUZZER or EVENT IN
SPEED-ALARM C
SPEED-ALARM H
+12V
GND
-
-
-
-
-
GND
DC_N
PWR_SW
GND
GND
TZT9 TZT9
TZT9 TZT9
3
7
Remark (Port No.)
CAN bus Power IN. When 12V DC power is
applied to these pins, the CAN bus port will
be powered (up to 1 ampere).
External Buzzer Output or MOB/Event Input
(Contact Closure)
Speed alarm contact. Can trigger an exter-
nal alarm or device when speed exceeds
the limit specified.
External buzzer power ONLY (100mA Max)
GND for Event/MOB Input
For debug
2. WIRING
TZT14 TZT14
TZT14 TZT14
2-3