Furuno TZT9 Installation Manual page 28

3. SETTING UP THE EQUIPMENT
Menu item
[Transducer Draft
Source]
[Keel Draft]
[Average Boat Speed]
[Nav Data Maximum
Depth]
Menu Item
[Number of Engine]
[Max. RPM]
[Red Zone RPM]
[Red Zone Oil Pressure]
[Red Zone Temperature]
[NickName Engine 1 to 4]
Menu Item
[Number of Tank]
[NickName Tank 1 to 4]
Menu Item
[Tank 1 to 4] Select the tanks to calculate the fuel consumption.
Menu Item
[GP330B WAAS Mode]
[WS200 WAAS Mode]
3-6
Description
Select the draft source to use on the dis-
play, among the following:
Automatic: Use the offset value in the
DPT sentence. If the DPT sentence
does not have an offset value, the value
entered at Transducer Draft (page 3-11)
is used.
Hardware: Use the offset value in the
DPT sentence from an echosounder.
Manual: Use the value entered at
Transducer Draft (page 3-11).
Set the keel draft.
Select your boat type to use for average
speed calculation.
Select the maximum depth for naviga-
tion data.
Menu Initial Setup (Engine)
Description
Select the number of engines on your
boat.
Set the maximum rpm of your engine to
show on the RPM display.
Set the starting value for the red zone area
of the tachometer.
Set the starting value for the red zone area
of the oil pressure meter.
Set the starting value for the red zone area
of the engine temperature indicator.
Change the nickname for engine 1 to 4.
Menu Initial Setup (Fuel)
Description
Select the number of fuel tanks on your
boat.
Change the nickname for fuel tank 1 to 4.
Manu Initial Setup (Use Fuel Tank for calculations)
Description
Menu Initial Setup (Data Acquisition)
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Options (setting range)
[Automatic], [Hardware], [Man-
ual]
0.0 to 99 ft
[Sailing], [Commercial], [Pow-
erboat]
[Very Shallow] (under 10 m),
[Shallow] (10 to 20 m), [Deep]
(20 to 200 m), [Very Deep] (200
to 2000 m)
Options (setting range)
[1], [2], [3], [4]
1000 to 20,000 rpm
0 to 20,000 rpm
0 to 999 kPa
0°F to 999°F
Options (setting range)
[1], [2], [3], [4]
Options (setting range)
[ON], [OFF]
Options (setting range)
[ON], [OFF]