Programming Transmitters To The Vehicle - Chevrolet 2010 Cobalt Owner's Manual

Hide thumbs Also See for 2010 Cobalt:
Table of Contents

Advertisement

(Lock): Press to lock all the doors. The interior
lamps turn off after all of the doors are closed.
If enabled through the Driver Information Center (DIC),
the remote lock feedback can be programmed to have
the horn chirp and/or the turn signals flash to confirm
locking. See LOCK HORN and LIGHT FLASH under
DIC Vehicle Personalization on page 4 46.
Pressing
may also arm the content theft-deterrent
system. See Content Theft-Deterrent on page 3 16.
(Unlock): Press to unlock the driver door. If
pressed again within five seconds, all remaining doors
unlock. The interior lamps turn on and stay on for
20 seconds or until the ignition is turned on. If enabled
through the DIC, the remote unlock feedback can be
programmed to have the horn chirp and/or the turn
signals flash to confirm unlocking. See UNLOCK
HORN and LIGHT FLASH under DIC Vehicle
Personalization on page 4 46.
The high beam headlamps and parking lamps may turn
on when
is pressed. See EXT (Exterior) LIGHTS
under DIC Vehicle Personalization on page 4 46.
Pressing
on the RKE transmitter disarms the content
theft deterrent system. See Content Theft-Deterrent on
page 3 16.
(Remote Trunk Release): Press and hold for
approximately one second to open the trunk. The trunk
will open using the transmitter when the vehicle speed
is less than 2 mph (3 km/h) if the vehicle has a manual
transmission, when the ignition is off, or when the
vehicle shift lever is in P (Park) if the vehicle has an
automatic transmission.
(Vehicle Locator/Panic Alarm): Press to locate
the vehicle. The horn sounds three times and the
headlamps and turn signals flash three times.
is
Press and hold
the panic alarm. The horn sounds and the headlamps
and turn signals flash for 30 seconds. Press
cancel the panic alarm.
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to the vehicle will
work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to the vehicle, all remaining transmitters
must also be programmed. Any lost or stolen
transmitters no longer work once the new transmitter
is programmed. Each vehicle can have up to four
transmitters programmed to it.
I n f o r ma t i o n P r o v i d e d b y :
for more that two seconds to sound
again to
3-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents