Programming Transmitters To The Vehicle; Battery Replacement - Chevrolet 2009 Suburban Owner's Manual

Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to this vehicle
will work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to this vehicle, all remaining transmitters
must also be reprogrammed. Any lost or stolen
transmitters will no longer work once the new transmitter
is programmed. The vehicle can have a maximum of
eight transmitters programmed to it. See "Relearn
Remote Key" under DIC Operation and Displays
(With DIC Buttons) on page 3-52 or DIC Operation
and Displays (Without DIC Buttons) on page 3-58 for
instructions on how to program RKE transmitters to the
vehicle.

Battery Replacement

Replace the battery if the REPLACE BATTERY IN
REMOTE KEY message displays in the DIC. See
"REPLACE BATTERY IN REMOTE KEY" under DIC
Warnings and Messages on page 3-64 for additional
information.
Notice: When replacing the battery, do not touch
any of the circuitry on the transmitter. Static from
your body could damage the transmitter.
To replace the battery:
1. Separate the transmitter with a flat, thin object
inserted into the notch on the side.
2. Remove the old battery. Do not use a metal object.
3. Insert the new battery, positive side facing down.
Replace with a CR2032 or equivalent battery.
4. Snap the transmitter back together.
2-7