Advertisement
F E AT U R E S - O P E R AT I O N S
SAVE THESE
INSTRUCTIONS
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Place heater on firm level surface.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500
Watts, this unit draws 12.5 Amps.
4. There is a cord wrap at the bottom of the heater to
hide extra cord or wrap the cord for storage.
CONTROL PANEL
Figure 1
A
B
A. Mode Control
B. Thermostat Control
C. Power Light
D. Cord Wrap (not
shown)
C
D
Mode Control
Turn the Mode Control to the desired setting:
- Off Mode
If you want to shut off the heater at any time during
operation, turn the Mode Control to
Light will remain lit until the heater is unplugged.
1 - LOW Heat
The heater will run continuously at 750W.
2 - HIGH Heat
The heater will run continuously at 1500W.
NOTE: To start the heater operation, make sure the
Thermostat Control is turned fully clockwise to the highest
position (7).
Rotating Grill Oscillation
This heater has rotating grill oscillation feature. To
activate, turn the Mode Control left to the High/Low
(2/1) settings. When rotating, the heat flow will cover a
wider area and help to circulate heat throughout the
room. To stop rotating grill, turn the Mode Control right to
the High/Low (2/1) settings.
NOTE: The grill may spin in both directions. If the grill is
touched while rotating, the grill may spin in the opposite
direction. This is normal and does not affect the rotating
grill feature.
Thermostat Control
1. Before setting the thermostat, allow heater to
operate and warm up the room. Set the thermostat to
the highest setting (7) to start the heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the fan/
heater stops operating. This is done by turning the
Thermostat Control counter-clockwise and select from
the 7 temperature levels (1-7).
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, turn the thermostat control clockwise to the
highest setting (7).
position. Power
Advertisement
