Table of Contents
Advertisement
F E AT U R E S - O P E R AT I O N S
Base Assembly
Step 1:
If the base is in two halves, snap them
together by sliding slots of one base half into
slots of second base half. Refer to Figure 3.
Step 2:
Run the power cord through the center of the
assembled base. To assemble the base to the
unit (either one or two-piece base) first make
sure the side marked "Rear" is facing the
back of the heater. Line up holes of the base
with holes on bottom of pedestal (or heater
housing if no pedestal is included), and secure
with 4 provided screws. Refer to Figure 4.
Step 3:
Lace the power cord through the cord minders
on the underside of the base. Refer to Figure 5.
Step 4:
Turn the heater right side up and place on a
flat level surface prior to beginning operation.
OPERATING INSTRUCTIONS
1. Make sure the unit is in the OFF (
before plugging the heater into the outlet.
2. Place heater on a firm, level surface.
3. Plug heater into a standard outlet. Once plugged in,
the Power Light will illuminate.
NOTE: Remove the plastic film from the control panel
before using (if included).
Figure 6
CONTROL PANEL
) position
Mode Control
(Settings: Off, Fan
only, Low Heat,
High Heat)
Thermostat Control
with FrostProtect™
Setting
Oscillation Switch
(if applicable)
NOTE: Avoid overloading your circuit by not using other
high wattage appliances in the same outlet. At 1500
watts, this unit draws 12.5 Amps.
Mode Control
Turn the Mode Control to the desired setting:
- Off Mode
If you want to shut off the heater at any time during
operation, turn the Mode Control to Off (
Power Light will remain lit until the heater is unplugged.
- Fan only Setting
Heater will run at fan-only operation without heat output.
1 - LOW Heat
The heater will run continuously at 750W.
2 - HIGH Heat
The heater will run continuously at 1500W.
NOTE: To start the heater operation, make sure the
Thermostat Control is turned fully clockwise to the highest
position.
Thermostat Control
1. Before setting the thermostat, allow heater to operate
and warm up the room. Set the thermostat to the
highest setting to start the heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the fan/
heater stops operating. This is done by moving the
Thermostat Control counter-clockwise.
3. The thermostat will now automatically maintain the
pre-set temperature level by turning the heater ON
and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, turn the thermostat control clockwise to the
highest setting or operate in manual mode at either High
(2) or Low (1) setting.
- FrostProtect
setting
TM
Turn the Thermostat Control to the FrostProtect
setting, the heater will turn on automatically if the
temperature goes below 5° C.
CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN
OPERATION.
) position.
(
)
TM
Advertisement
Table of Contents
