Advertisement
F E AT U R E S - O P E R AT I O N S
TECHNICAL SPECIFICATIONS
• Amps: 6.7
• Wattage: 800W (+5% –10%)
• Working voltage: 120V AC/60Hz
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Place heater on a firm, level surface.
3. Plug heater into a standard outlet. Once plugged in,
the Power Light will illuminate.
4. There is a cord wrap at the bottom of the heater to
hide extra cord or wrap the cord for storage.
NOTE: Avoid overloading your circuit by not using other
high wattage appliances in the same outlet. At 800 watts,
this unit draws 6.7 Amps.
CONTROL PANEL
Figure 1
E
A
B
A. Power Button
B. Motion Sensor
C. Power Light
D
C
D. Motion Sensor
Indicator Light
E. Hi/Lo Indicator Lights
Power Mode
Press the Power Button ( ) to select the desired heat
settings. Each press of the button will cycle through the
below settings and the corresponding indicator light will
illuminate:
1. Hi - HIGH Heat
The first press of the Power Button ( ) sets the heater
at High Heat setting, the Hi indicator light will illuminate.
The heater will run continuously at 800W.
2. Lo - LOW Heat
Press the Power Button ( ) again will switch to the Low
Heat setting with the Lo indicator light illuminated. The
heater will run continuously at 400W.
3. The next press of the Power Button ( ) will turn off
the heater, it will automatically perform a cool down
process (blowing cold air), the Lo indicator light will blink
for 15 seconds until cool down is completed, and then all
indicator lights are off.
CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN
OPERATION.
Motion Sensor
This heater is equipped with motion sensor feature, this
works with any heat setting.
1. To activate the motion sensor feature, turn the switch
located at the back of the heater to Sensor ON (see
Figure 2). Ensure the heater is under working mode,
otherwise, press the Power Button ( ) to activate
heater operations. The motion sensor indicator light
(Sensor) on control panel will illuminate in GREEN to
indicate that motion sensor feature is activated.
2. If there is no motion detected after 30 minutes of
operation, the unit will stop producing heat, and the
motion sensor indicator light will begin to blink in
GREEN slowly.
Advertisement
