Blower Installation Instructions - Drolet Escape 1400-I Insert Owner's Manual

2.5 Blower installation Instructions

The blower is already attached to the unit at the factory with two tie straps. Remove the two tie straps
and clip the blower assembly back onto the unit.
14
Align the notch in the faceplate
extension with the bolt (O) welded to
the air jacket located (see DETAIL
D) and slide the faceplate assembly
just over the washer (P) and bolt's
head (Q). Then push towards the
fireplace.
If necessary, adjust the height of the
insert using the leveling bolts on each
side of the convection air jacket until
the faceplate is properly seated on the
floor of the hearth extension.
Once the faceplate is in place, secure
the assembly by tightening nut (Q)
using a 7/16" (11 mm) open end
wrench.