Landroll Scraper; Chain Adjustments - Ransomes Matador Safety, Operation & Maintenance Manual

8 ADJUSTMENTS
8.7

LANDROLL SCRAPER _______________________________________________

To adjust the scraper, loosen the screws (A) at each end of
the scraper. Adjust the scraper position and tighten the
screws.
8.8

CHAIN ADJUSTMENTS ______________________________________________

Remove the chain case cover to access the chains. The
chains need a degree of free movement Measure at the
center of the longest side. This free movement must not be
more than half the height of the chain from its centre line.
Make sure each chain is free from tight sections.Replace
the chains as required.
Adjustment.
Chain A:
Loosen the nut (a). The chain wheel is installed on a slot.
Move the chain wheel until the correct tension is set.
Tighten the nut (a).
Chain B:
Loosen the nuts (b) and move the adjuster along the slots
until the correct tension is set. Tighten the nuts (b).
Chain C:
Loosen the nut (c) and move the adjuster along the slots
until the correct tension is set. Tighten the nut (c).
NOTE: DO NOT OVER TIGHTEN.
Check there are no tight sections on any of the chains. Replace the chain case cover.
en-42
A
A
C/H
a
A
b
B
C
c