Note: The receiver's new host name takes effect after the reboot.
5.3.5. Setting up PIN Pairing Method
Follow the procedure below to set up PIN pairing method:
1. Go to the Features tab page by clicking the Features tab.
2. Go to the PIN setup section, and set the Force PIN Pairing feature to On or Off.
Select "Off" to disable the PIN enforcement function. PIN or PBC pairing is used
when connecting your device to the receiver for the first time.
Select "On" to enable the PIN enforcement function. In this case, you must enter a
PIN code on the device connecting to the receiver every time or the first time.
Note: Some wireless display source device may not support PIN entry and may not
be able to connect with the ScreenBeam receiver if this mode is enabled. Refer to
the device's user manual for detail about enabling the PIN connection.
3. Select a PIN pairing method.
Every time: You are required to provide the PIN every time you connect your device
to the receiver.
the 1st time: You are required to provide the PIN the first time you connect your
device to the receiver.