If any error message is displayed during the measurement, resolve the problem and perform YPAO again. Error message can be confirmed and controlled by viewing both a TV

monitor and the front display.

TV monitor

■

Cause and remedy for each error message

Error message

Cause

E-1:No Front SP

Front speakers are not

(E-1:NO FRNT SP)

detected.

E-2:No Sur. SP

Either of surround

(E-2:NO SUR SP)

speakers is not detected.

E-5:Noisy

The noise is too loud.

(E-5:NOISY)

E-7:No MIC

The YPAO microphone has

(E-7:NO MIC)

been removed.

E-8:No Signal

The YPAO microphone

(E-8:NO SIGNAL)

cannot detect test tones.

E-9:User Cancel

The measurement has

(E-9:CANCEL)

been canceled.

E-10:Internal Err.

An internal error has

(E-10:INTERNAL)

occurred.

YPAO

VOL.

ENHANCER

iPod

CHARGE

SLEEP

STEREO

TUNED

E-1:NO FRNT SP

Front display

Follow "Procedure to exit YPAO" to exit YPAO, turn off the unit, and then check the speaker connections. After removing problems, turn on the unit, and

then perform YPAO again.

Keep the room quiet and select "RETRY (Retry)" in step 2 of "Procedure to exit YPAO" to restart YPAO for an accurate measurement. Selecting

"PROCEED (Proceed)" allows you to continue measuring, but may not achieve the optimal results.

We recommend selecting "RETRY (Retry)" or "EXIT (Exit)" to retry YPAO again from the beginning.

Connect the YPAO microphone to the YPAO MIC jack firmly and select "RETRY (Retry)" in step 2 of "Procedure to exit YPAO" to restart the measurement.

If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.

Select "PROCEED (Proceed)" in step 2 of "Procedure to exit YPAO" to resume the measurement. Select "RETRY (Retry)" to restart the measurement from

first.

Follow "Procedure to exit YPAO" to exit YPAO, turn off and on the unit. Perform YPAO again. If this error occurs repeatedly, contact the nearest authorized

Yamaha dealer or service center.

■

Procedure to exit YPAO

Check the contents of error message, and then press ENTER.

Press the cursor key ( ) to select "EXIT (Exit)" from the following

choices, and then press ENTER.

Choices: PROCEED (Proceed) (E-5, E-9 only), "RETRY (Retry)," "EXIT (Exit)"

Press the cursor key ( ) to select "Exit (Exit)" from the following

choices, and then press ENTER.

Choices: Start (Start), Exit (Exit)

Remove the YPAO microphone.

Remedy