Transferring A Call To Another User's Voice Mail - 3Com VCX Manual

64 C 6: S
HAPTER TANDARD
Transferring a Call
to Another User's
Voice Mail
F
EATURES
If you have not enabled this feature code, you can send a call that is
■
ringing (and all subsequent calls) to your voice mailbox by pressing
Feature + 440.
To disable this feature, press Feature + 440. All calls ring normally.
■
You can transfer a connected call directly to another subscriber's voice
mail rather than that subscriber's telephone extension. The subscriber can
be located locally or at a remote site.
To transfer a call to another subscriber's voice mail:
1 While on a call, press Feature + 441.
The Display Panel shows the following prompt:
Transfer VMail Number:
2 Enter the extension of the subscriber whose mailbox will receive the call.
The caller hears the mailbox greeting of the target subscriber but the
subscriber's telephone does not ring.
Alternatively, you can use the following procedure:
1 While on a call, press Transfer.
2 Enter the transfer to another subscriber's voice mail feature code in the
following format:
*441*<extension>
For , you can either enter the telephone extension of the
<extension>
recipient, press a speed dial button mapped to that extension, or press a
bridge line button (Basic phones do not support bridging) mapped to that
extension.
3 Press the Transfer button again, then hang up.
For example, extension 1001 calls extension 1000. Extension 1000 wants
to transfer the call to the voice mailbox of extension 1002. In this case,
extension 1000 performs the following steps:
Presses Transfer.
Enters
*441*1002
Presses Transfer.
Hangs up.
.