Serial Transfer Feature Code Method; Muting Calls; Mute Ringer - 3Com VCX Manual

44 C 4: B
HAPTER ASIC

Muting Calls

Mute Ringer

T O
ELEPHONE PERATION
3 Press the mapped Attendant Serial Calling button again on the Attendant
Console to complete the call.

Serial Transfer Feature Code Method

1 While on a call, press Feature + 471. The call is placed on hold, you hear
a dial tone, and the system prompts you to enter a destination number.
2 Dial the number to which you want to transfer the call, and then press #
to complete the call.
3 Hang up.
When the destination telephone hangs up, the caller returns to you.
Serial transfers:
Apply to a single transfer. Repeat for subsequent transfers even for the
■
same caller.
Can be mapped to a button on an Attendant Console.
■
That cannot be completed return directly to the attendant.
■
If the calling party reaches the called party's voice mailbox, the calling
■
party can press 99 to return to the attendant.
You can prevent callers from hearing you by turning off the telephone's
microphone when you are using the handset or headset, or when your
telephone is in speaker phone mode.
To mute your telephone:
1 While you are on a call, press Mute. The light next to the Mute button
comes on. Callers cannot hear you.
2 To turn this feature off, press Mute.
You can prevent the telephone's ringer from ringing by enabling this
feature. By default, the telephone's ringer is enabled (feature disabled).
You can enable or disable the telephone's ringer at any time while either
on the telephone or on-hook, but the change takes effect on the next
incoming call.
All non-ringer tones are unaffected. All ring tones, such as, internal
domain, external domain, and anonymous tones are affected for all
primary, bridge, and hunt-group calls. A user with a telephone on