Table of Contents
Advertisement
9. Programmable Features
9.5.1 Programmable functions
{j/OK}
{C}
{>}{e}{v}
Helpful hints:
L To exit programming, press {ih} at any
time.
9.5.2 Alarm
Setting alarm
An alarm will sound for 3 minutes at the set time
once or daily.
Set the date and time beforehand (page 20).
1. Press {j/OK}.
2. Select "Handset Setup", then press {>}.
3. Select "Time Settings", then press {>}.
4. Select "Alarm", then press {>} 2 times.
5. Select an alarm mode, then press {>}.
– "Once": The alarm will sound once at the
set time. Enter the desired day and month
by selecting 2 digits for each.
– "Daily": An alarm will sound daily at the
set time.
– "Off" (default): Turns the alarm OFF.
Press {>} again, then press {ih} to
finish.
6. Enter the desired hour and minute by
selecting 2 digits for each.
L You can select "AM", "PM" or 24-hour
time entry by pressing {*} repeatedly.
7. Press {j/OK}.
8. Select the ring tone that will sound at the set
time, then press {>}.
9. Select "Save", then press {>}.
10. Press {ih}.
Note:
L To stop the alarm, press any dial key.
L When the cordless handset is in talk or
intercom mode, the alarm will not sound until
the call has ended.
L Alarm volume depends on cordless handset
ringer volume (page 18).
72
L The alarm will sound at the set time even
L If you select "Once", the setting will be
9.5.3 Ringer options
Changing ring tones
{ih}
You can choose the ring tone used by the
cordless handset.
"Ext. Ringtone": Selects the ring tone for
outside calls.
"Int. Ringtone": Selects the ring tone for
intercom calls.
1. Press {j/OK}.
2. Select "Handset Setup", then press {>}.
3. Select "Ringer Setup", then press {>}.
4. Select the desired item, then press {>}.
5. Select the desired ring tone, then press {>}.
6. Press {ih}.
Note:
L If you select one of the melody ring tones, the
L The preset melodies in this product are used
L To set the base unit ring tone, see feature #17
9.5.4 Display setup
Selecting the standby mode display
"Base Number": The current base unit number
is displayed.
"Handset Number": The current cordless
handset number is displayed.
"Off" (default): Only the current date and time
are displayed.
1. Press {j/OK}.
2. Select "Handset Setup", then press {>}.
3. Select "Display Setup", then press {>}.
4. Select "Standby Display", then press
5. Select the desired setting, then press {>}.
6. Press {ih}.
Note:
L If "Base Number" is selected and the
when the ringer is turned OFF.
changed to "Off" after the alarm sounds.
ring tone will continue to sound for several
seconds if the caller hangs up before you
answer. You may hear a dial tone or no one
on the line when you answer a call.
with permission of © 2004 M-ZoNE Co., Ltd.
on page 63.
{>}.
current base unit number is 2, "-2-" is
displayed.
Advertisement
Table of Contents
