Printing A Font Sample List; Printing A Directory List - Lexmark C920 User Manual

Printing a network setup page
If the printer is attached to a network, print a network setup page on the printer to verify the network connection. This page
also provides important information that helps in configuring for network printing.
1
Make sure the printer is on.
2
Press
3
Press
4
Press
5
Check the first section on the network setup page, and confirm that Status is "Connected."
If Status is "Not Connected" is on the page, the LAN drop may not be active, or the network cable may be
malfunctioning. Consult a system support person for a solution, and print another network setup page to verify that
the printer is connected to the network.

Printing a font sample list

To print samples of the fonts currently available for your printer:
1
Make sure the printer is on and the Ready message appears.
2
Press
3
Press
4
Press
5
Press
.

Printing a directory list

A directory listing shows the resources stored in flash memory or on the hard disk. To print a listing:
1
Make sure the printer is on and the Ready message appears.
2
Press
3
Press
4
Press
5
Press
6
Press
The message Printing Directory List appears on the display.
The printer returns to the Ready state after the directory list prints.
Downloaded From ManualsPrinter.com Manuals
on the operator panel.
until Reports appears, and then press
until Network Setup Page appears, and then press
Note: If an optional MarkNet N8000 series internal print server is installed, Print Net1 Setup appears on
the display.
on the operator panel.
until Reports appears, and then press
until Print Fonts appears, and then press
until the appears next to PCL Emul Fonts, PostScript Fonts, or PPDS Fonts, and then press
on the operator panel.
until Reports appears.
.
until Print Directory appears.
.
Printing
.
.
.
Printing a network setup page
55
.