Table of Contents
Advertisement
2. Wi-Fi Setup
Depending on where your presentation content is located, you may select one of the following
WiFi modes from the NovoConnect home screen.
A) Client mode – for content residing in a private cloud or the Internet cloud
B) Hotspot mode – for content residing on your PC or Tablet
C) Either – for content residing on your microSD card
The NovoConnect B360 defaults to start up in WiFi Hotspot mode, which is the shortest path to
make a wireless presentation without needing a WiFi AP. If this is your preferred mode, you
may skip to next chapter for steps to making a presentation.
If you would like to make your presentation in a WiFi AP networked environment, please refer
to the "Client Mode" section in this chapter.
2.1 Hotspot Mode
Right out of the box, NovoConnect's WiFi is set to function as a WiFi Hotspot and will stay in this
configuration until you alter it. The default SSID for the WiFi Hotspot is "NVC_XXXXX", where
"XXXXX" is a machine generated string of characters and numbers. A mouse is required for the
following steps.
If you alter your settings and then choose to revert to Hotspot mode, on the NovoConnect
home screen, select WiFi-> Hotspot Mode->Apply.
For a PC to connect to the B360 Hotspot, click the network icon
the SSID of the NovoConnect B360 device shown on the home screen (for example, NVC_DC9AB)
and click Connect.
For a Mac to connect to the B360 Hotspot, click the network icon
NovoConnect B360 device shown on the home screen (for example, NVC_DC9AB) and click Join.
Ignore any security warnings.
For a tablet to connect to the B360 Hotspot, enable WiFi and go to the WiFi AP list. Select the
SSID of the NovoConnect B360 device shown on the home screen (for example, NVC_DC9AB).
Note: In Hotspot mode operation, all participating presentation devices must be connected to
the same NovoConnect B360 WiFi HotSpot.
Copyright © 2013 DELTA Electronics, Inc. All rights reserved.
or
on task bar. Select
Select the SSID of the
.
Page 10
Advertisement
Table of Contents
