Table of Contents
Advertisement
Recording
Record Screen
1
2
3
1. Record indicator - When a channel is recording the record indicator will appear beside the channel number.
2. Audio indicator - The audio indicator will appear on the top left corner on the display the audio is aasigned to. See
AUDIO PORT SETUP on page 17 to configure this setting.
Indicates the audio port is assigned to a channel and the audio port is on.
Indicates the audio port is off.
Indicates the audio port is currently recording and audio output is on.
Note:
Pushing the DOWN button on the front panel or the MUTE button on the remote will mute the audio output. The audio
inout can still be recorded while the output is muted.
3. Channel - The number on the top left corner of each display indicates the the channel.
4. Record mode - This indicates which record schedule the DVR is set to.
a. A-REC - Current record schedule is set to NORMAL-RECORD mode.
b. S-REC - Current record schedule is set to SENSOR-RECORD mode
c. N-REC - Current record schedule is set to NO-RECORD mode.
5. Hard drive information - This shows which hard drive is been recorded to and the percentage currently used.
[M] indicates MASTER HDD, [S] indicates SLAVE HDD and *75% indicates 75 percent of the hard drive is full.
6. Date & Time stamp - Current date and time.
Recording and stopping a recording
1. Push the RECORD button in the diplay mode (quad or individual view) to begin recording.
2. Push the STOP button to stop the recording.
Note:
If the password is currently enabled you will be prompted for the password; only the correct password will allow you to
stop the recording.
4
5
6
Advertisement
Table of Contents
