Troubleshooting; The Machine Will Not Start; The Machine Loses All Power During A Program; The Machine Leaks Water - Asko T884XLHP Operating Instructions Manual

TROUBLESHOOTING

NOTE!
When starting the tumble dryer for the first time or
after a long period without use, you may notice a slight
thumping noise. This noise is completely normal and
will disappear after a few loads.

THE MACHINE WILL NOT START

Check:
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been selected.
To cancel Delayed Start, press the Stop button for
three seconds.
• that the plug is connected.
• that the main fuses have not blown.
THE MACHINE LOSES ALL POWER
DURING A PROGRAM
Contact the service division.

THE MACHINE LEAKS WATER

Check that the autofilter and its seal are installed
correctly and not faulty.

DRYING TAKES TOO LONG

• Check that the lint filter is not clogged (see the Care
and cleaning chapter).
• Empty the condensed water container. Clean the
evaporator filter (net filter + foam filter), evaporator, lint
filter and autofilter, see chapter Care and cleaning.

ERROR MESSAGES

• If Over Flow appears on the display, the condensed
water container is full or the evaporator filter is
blocked. Empty the container, clean the filter and
restart the machine. See the Care and cleaning
chapter.
• Read Drying takes too long in this chapter if Max
program time appears on the display.
• If Clean Lint Filter appears on the display, clean the
lint filter.
• If Clean condenser appears on the display, clean the
evaporator. See the Care and cleaning chapter.
• If Clean auto filter appears on the display, clean the
auto filter. See the Care and cleaning chapter.
• Call the service division if Thermistor fault appears on
the display.
• Press the Stop button to close any error messages.
17