Dedicated iLO management port option
To install the component:
Power down the server (on page 28).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 29).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
Using a flat screwdriver, toggle the knockout to loosen it, and then pull it out of the chassis.
5.
("Access
panel" on page 35).
Removal and replacement procedures 54