HP ProLiant DL320e Gen8 Maintenance And Service Manual page 66

CAUTION: Do not overtighten the screws as this might damage the board, connectors, or screws
and voids the warranty of the board.
Install the heatsink:
8.
Position the heatsink on the processor backplate.
a.
Tighten one pair of diagonally opposite screws halfway, and then tighten the other pair of screws.
b.
Finish the installation by completely tightening the screws in the same sequence.
c.
CAUTION: When returning a damaged system board to HP, always install all processor socket
covers to prevent damage to the processor sockets and system board.
Install the processor socket cover on the failed system board.
9.
Install all components removed from the failed system board.
10.
Connect all cables disconnected from the failed system board.
11.
Install the PCI riser cage.
12.
Install the air baffle.
13.
Install the access panel.
14.
Do one of the following:
15.
Removal and replacement procedures 66