Table of Contents
Advertisement
[05]
First System Options
1 Quick-Exit Enable / Disable
ON: Quick-Exit Disabled.
•
OFF: Quick-Exit Enabled. With the system armed in the Home or Away Mode, enter an Access
Code and use the
Exit" prompt is displayed; when displayed, press the
feature. The user will be allowed two minutes to leave the premises through a Delay Zone.
Only one Delay Zone may be activated; any other activity on another Delay Zone will
generate an alarm. If the Delay zone is still open two minutes after the Quick-Exit command
is entered, the Entry Delay will be initiated.
2 Auto-Interior Enable / Disable
ON: Auto-Interior enabled. The System will determine whether or not Interior zones are to be
automatically bypassed when the system is armed; the user will not be given the option of
arming in the Home or Away Modes.
If a Delay zone is opened and closed after an Access Code is entered to arm the system,
the system will arm in the Away Mode and all Interior zones will be armed. If no Delay zone
is opened after an Access Code is entered to arm the system, the system will arm in the
Home Mode, and Interior zones will be automatically bypassed.
In the default setting, the system allows the user to select between arming in the Home
Mode or the Away Mode. The WLS900 Owner's Manual describes arming that allows
the selection of either the Home Mode or the Away Mode. If the Auto-Interior option is to
be enabled, the user should be provided with these instructions for arming their
system:
• All zones on the system will be active if an Entry/Exit Door is opened and then
closed during the Exit Delay.
• If the Entry/Exit Door is not opened and then closed during the Exit Delay, all Interior
Zones will be automatically bypassed when the system is armed.
•
OFF: Auto-Interior disabled. When arming the system, the user will be prompted with Keypad
messages to arm the system in either the Home or Away Mode. Refer to the Owner's Manual
for instructions on how to arm the system when the user may select between Home Mode
and Away Mode arming.
Chapter 8: System Programming Sections
-NO Key to scroll through the Keypad messages until the "Quick-
Enter an Access Code using the Number Keys. As each digit of the
code is entered, an "X" will appear on the Keypad screen. If a
mistake is made while entering the Access Code, press the
to clear the mistake and enter the Code again.
If the system is ready to be armed, this message will be displayed,
then the next message will be displayed. If the system is not ready
to be armed or if there are conditions on the system of which the
user should be aware, other messages may be displayed at this
time.
If the system is ready to be armed, this message will be displayed.
Press the
-YES Key to arm the system, or press the
to bypass zones. When the system is armed:
When the
-YES Key is pressed, the Exit Delay will begin and this
message will be displayed for a few seconds. With 30 seconds
remaining in the Exit Delay, the Sounder will begin to "beep" once
every second. During the last 10 seconds of the Exit Delay, the
Sounder will "beep" twice every second. At the end of the Exit
Delay, the Sounder will be silenced and the system will be armed.
-YES Key to use the Quick-Exit
Key
-NO Key
27
Advertisement
Table of Contents
