Table of Contents
Advertisement
Telephone
192
cVd the COMAND controller and press
W to confirm.
Address book: select
X
in the telephone basic menu by sliding
VÆ and turning cVd the COMAND
controller and press W to confirm.
Select
Address Book
X
confirm.
To switch from the character bar to the
X
list: slide ZV the COMAND controller until
the character bar is hidden.
or
Select ¬.
X
To call a contact: select by sliding ZVÆ
X
or turning cVd the COMAND controller
and press W to confirm.
i
The phone book is also available via the
on-board computer (
Calling up contacts using the character
bar
Phone book: select
X
basic menu by sliding VÆ and turning
cVd the COMAND controller and press
W to confirm.
Address book: select
X
in the telephone basic menu by sliding
VÆ and turning cVd the COMAND
controller and press W to confirm.
Select
Address Book
X
confirm.
To select a character: select by sliding
X
ZVÆ or XVY the COMAND controller and
press W to confirm. Repeat this procedure
until COMAND automatically switches over
to the list.
You determine the first letter of the entry
you are looking for with the first character
you enter. If there are similar entries, the
next character which is different will be
displayed and offered for selection.
9
Only available with the "Change contact" function.
Data/Connections
and press W to
page 344).
Y
Name
in the telephone
Data/Connections
and press W to
i
You can also use the telephone number
keypad to enter characters.
Creating new contacts/changing
contacts
i
In certain countries, this function stops
being available from a vehicle speed of
more than approximately 3 mph (5 km/h).
As soon as the speed falls below
approximately 2 mph (3 km/h), the
function becomes available again.
i
You can enter address data directly into
the address book. If you store contacts in
the phone book, these are also saved in the
address book.
i
Automatically imported contacts cannot
be edited. They have to be saved first
before being copied to the COMAND
address book.
Call up the contact (
X
Y
Select
Options
by sliding VY and turning
X
cVd the COMAND controller and press
W to confirm.
Select
New Entry
or
Change
X
W to confirm.
The input menu with data fields appears.
9
page 191)
.
and press
Advertisement
Chapters
Table of Contents
