Mercedes-Benz 2013 CL Operator's Manual page 148

Navigation
146
switched on and the GPS signal is strong
enough.
Moving the map and selecting the
destination
To scroll the map: slide XVY, ZVÆ or
X
aVb the COMAND controller.
To set the map scale: as soon as you turn
X
cVd the COMAND controller, the scale bar
appears.
Turn cVd until the desired scale is set.
X
Turning clockwise zooms out from the map;
turning counter-clockwise zooms in.
To select a destination: press W the
X
COMAND controller once or several times.
You will see either the address entry menu
with the destination address or, if COMAND
is unable to assign a unique address, a
selection list.
Select a destination by turning cVd the
X
COMAND controller and press W to
confirm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the entry Destination from
To start route calculation: select
X
and press W to confirm.
Entering an intermediate stop
Introduction
When route guidance is active, you can enter
an intermediate stop. Intermediate stops can
be predefined destinations from the following
categories that COMAND offers for selection:
Mercedes-Benz Service Center
R
Hospital
R
Gas Station
R
Parking Lot
R
Restaurant
R
However, you can also enter destinations
other than the predefined ones. To do this
select the menu item Other.
You can use the intermediate stop function to
influence route guidance to the main
destination. When you have reached your
intermediate stop, COMAND automatically
recalculates the route to the main
destination.
Entering predefined destinations
To activate navigation mode: press the
X
S function button once or twice.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
Select Stopover
X
Option 1: no intermediate stop has been
entered yet.
Select a category; see option 2.
X
Option 2: an intermediate stop has
already been entered.
Map.
Select Change Stopover
X
Start
confirm.
in the navigation
and press W to confirm.
and press W to