Mercedes-Benz 2013 CL Operator's Manual page 154

Navigation
152
Route guidance
General notes
G WARNING
COMAND calculates the route to the
destination without taking into account the
following, for example:
Traffic lights
R
Stop and right-of-way signs
R
Lane merging
R
Parking or stopping prohibited areas
R
Other road and traffic rules and regulations
R
Narrow bridges
R
COMAND may give incorrect navigation
commands if the data in the digital map does
not correspond with the actual road/ traffic
situation. For example, if the traffic routing
has been changed or the direction of a one-
way road has been reversed.
For this reason, you must always observe
applicable road and traffic rules and
regulations during your journey. Road and
traffic rules and regulations always have
priority over the navigation commands
generated by the system.
Route guidance begins once a route has been
calculated ( page 141).
Y
COMAND guides you to your destination by
means of navigation commands in the form
of audible navigation announcements and
route guidance displays.
The route guidance displays can only be seen
if the display is switched to navigation mode.
If you do not follow the navigation
announcements or if you leave the calculated
route, COMAND automatically calculates a
new route to the destination.
If the digital map contains the corresponding
information, the following applies:
when selecting a route, COMAND tries to
R
avoid roads that only have limited access,
e.g. roads closed to through traffic and non-
residents.
roads that have time restrictions (e.g.
R
closed on Sundays and public holidays) are
avoided for route guidance.
Change of direction
Introduction
Changes of direction have three phases:
preparation phase
R
announcement phase
R
change-of-direction phase
R
Preparation phase
COMAND prepares you for the upcoming
change of direction. Based on the example
display below, the change of direction is
announced with a message. You see the full-
screen map.
Example display: preparation phase
Next road
:
Route
;
Current vehicle position (the tip of the
=
triangle indicates the vehicle's direction
of travel)
Current road
?
The display in ? depends on the setting
selected under "Text information on the map"
( page 171).
Y
Announcement phase
COMAND announces the imminent change of
direction. With reference to the following
example display, the announcement is given