Mercedes-Benz 2013 CL Operator's Manual page 169

will appear asking whether you wish to
overwrite the existing data.
Select Yes or No and press W to confirm.
X
If you select Yes, COMAND stores the data.
Deleting a destination or the home
address from the destination memory
To activate navigation mode: press the
X
S function button once or twice.
To show the menu: press W the COMAND
X
controller.
Select Destination in the navigation
X
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
Select From Memory and press W to
X
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
X
character bar: proceed as described in the
"Entering characters using the character
bar" section ( page 120).
Y
Option 2: destination memory list as
X
selection list: select a destination by
turning cVd the COMAND controller and
press W to confirm.
You see the address data of the selected
entry.
Select Delete and press W to confirm.
X
A prompt appears asking whether you wish
to delete the destination.
Select Yes or No and press W to confirm.
X
If you select Yes, COMAND deletes the
destination. You will see a message to this
effect.
If you select No, the process is aborted.
i
If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
has been started. If the memory is full,
COMAND deletes the oldest destination. You
can also save a destination from the list of
previous destinations in the destination
memory. It will be stored there permanently.
Storing a destination permanently in
the destination memory
Proceed as described in the "From the list
X
of previous destinations" section
( page 165).
Y
Storing the vehicle position in the list of
previous destinations
To activate navigation mode: press the
X
S function button once or twice.
To show the menu: press W the COMAND
X
controller.
Select Position in the navigation system
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Store Vehicle Position
X
press W to confirm.
COMAND stores the current vehicle
position as a destination in the list of
previous destinations.
Navigation
167
and
Z