Conference System
DCN-DIS Discussion Units (wired)
You can move the DCN cable from the rear side to the bottom side of the discussion unit.
Figure 5.11 Move the DCN cable
NOTICE!
The safety of this equipment has been tested according to the standards for moveable
equipment. Before you use this equipment as stationary equipment in a North American
country, contact your supplier.
You can install the discussion unit on a flat surface or in a recess. When you install the
discussion unit desk in a recess:
–
–
NOTICE!
When you install the discussion unit in a recess, make sure that the delegates or the chairman
can connect the headphones.
When you attach the discussion unit to a flat surface, put screws with a length of 8 mm in the
screw holes (no. 12). The distance between the centres of the screw holes is 34 mm.
Bosch Security Systems B.V.
TORX 8
5
1
4
Use the template.
Move the DCN cable to the bottom side of the discussion unit.
Installation and Operation manual
3
2
Installation | en
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
99