Bosch DCN Next Generation Installation And Operation Manual page 161

Conference System
Figure 6.73 Crimping the bush
Remove the ends of the copper wires
Do as follows:
9.
Figure 6.74 Cutting a copper wire
10. Push the copper wires to the mechanical stop of the stripping tool (tool 5). Remove the
Figure 6.75 Stripping a copper wire
Bosch Security Systems B.V.
Hold the crimping bush in position I with the stripping tool. Cut the copper wires at
position II with the cable cutter (tool 2).
I
II
red and brown insulations from the copper wires.
Installation and Operation manual
Connection | en 161
DCN-NG_IOM_V4.1 | V1.3 | 2012.07