Bosch DCN Next Generation Installation And Operation Manual page 210

210 en | Configuration
Dual delegate
When the discussion unit is in the dual delegate mode, it is a delegate device for 2 delegates.
The system sees the discussion unit as two separate devices, but it gives only one address to
the discussion unit. You can only put these types of discussion units in the dual delegate
mode:
–
–
–
–
When you put the discussion unit in the dual delegate mode, you must also install the DCN-
DISBDD Buttons.
Figure 7.16 DCN-DISBDD Buttons
NOTICE!
The DCN-DISBDD buttons come with a tool that you can use to remove the old buttons from
the discussion unit (refer to Section 5.4 DCN-DIS and DCN-WD Discussion units).
Single delegate with auxiliary control
When the discussion unit is in the single delegate with auxiliary control mode, it is a delegate
device for 1 delegate. The delegate can use the left microphone button as an auxiliary button.
For example, to activate an indicator.
NOTICE!
When the delegate pushes the auxiliary button, the auxiliary button makes an event. Use the
Open Interface to program the actions that must be started by the event. Refer to the
applicable Software User Manual for instructions that tell you how to program the Open
Interface.
You can only put these types of discussion units in the single delegate with auxiliary control
mode:
–
–
–
–
–
–
–
–
When you put the discussion unit in the single delegate with auxiliary control mode, you must
also install two microphone buttons (refer to Section 5.4 DCN-DIS and DCN-WD Discussion
units). For example, you can use the DCN-DISBCM Buttons.
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
DCN-DISD
DCN-DISDCS
DCN-WDD
DCN-WDDCS
DCN-DISD
DCN-DISDCS
DCN-DISV
DCN-DISVCS
DCN-WDD
DCN-WDDCS
DCN-WDV
DCN-WDVCS
Installation and Operation manual
Conference System
Bosch Security Systems B.V.