Bosch DCN Next Generation Installation And Operation Manual page 187

Conference System
Menu item
4A Input Mode
4B AGC
4C Level
4D Routing
4E Ctrl Thresh.
4F Unit Name
4G Defaults
Table 7.16 Setup sub-menu (* = default)
Bosch Security Systems B.V.
Parameter Value (read -only)
--- ---
Input: AGC:
Input 1 On, Off
Input 2 On, Off
Input 3 On, Off
Input 4 On, Off
Signal: Level:
Input 1 -6 to 6 dB (0 dB*)
Input 2 -6 to 6 dB (0 dB*)
Input 3 -6 to 6 dB (0 dB*)
Input 4 -6 to 6 dB (0 dB*)
Output 1 -24 to 6 dB (0 dB*)
Output 2 -24 to 6 dB (0 dB*)
Output 3 -24 to 6 dB (0 dB*)
Output 4 -24 to 6 dB (0 dB*)
Signal: Channel:
--, 00 to 31
Input 1
Input 2 --, 00 to 31
Input 3 --, 00 to 31
Input 4 --, 00 to 31
Output 1 --, PA, 00 to 31
Output 2 --, PA, 00 to 31
Output 3 --, PA, 00 to 31
Output 4 --, PA, 00 to 31
Signal: Level:
Output 1 -60 to -10 dB
Output 2 -60 to -10 dB
Output 3 -60 to -10 dB-60 to -
Output 4 10 dB
--- Name:
Analog Expander*
Custom name
--- ---
Installation and Operation manual
Configuration | en 187
Description
Gives access to the Input
Mode sub-menu (refer to
Section Input mode,
page 188).
Sets the automatic gain
control (AGC) of the audio
inputs on and off (refer to
Section Automatic gain
control (AGC), page 188).
The levels of the audio
inputs and the audio
outputs of audio expander.
The channel that is
attached to the audio input
or audio output of the
audio expander. (PA =
public address system.)
When an output is assigned
to an individual microphone
channel, the corresponding
contact is switched when
the level is above
threshold.
The name of the audio
expander (max. 16
characters).
Resets all of the units to
their factory defaults. The
unit name is not reset.
DCN-NG_IOM_V4.1 | V1.3 | 2012.07