Electrolux SkyLine PremiumS User Manual page 74

Anom- Type of
Description
aly anomaly
FLUE Stops oven SPI-FLASH memory
writing error
N°141
FrA1 Stops The FRAM ID is differ-
oven; fatal ent as expected
N°104
error
FrA2 Stop oven; The FRAM power fail
fatal error data calculated MD5 is
N°105
different as the stored
one
FrMC Stops The FRAM power fail
oven; fatal data calculated MD5 is
N°106
error different as the stored
one
FrrE
Stops oven FRAM memory read-
ing error
N°145
FrUE Stops oven FRAM memory writing
error
N°146
FSnr Warning Cooling fan issue
N°293
FUXX Stops oven Upper cavity motor
(XX = 00 failure
- 17)
GbbU Stops the Boiler gas burner
boiler locked
N°301
GbCd Cycle Cavity lower burner
paused locked
N°302
74
Possible causes
• Inlet air filter dirty
• Cooling fan failure
• Filter not present
Diagnostic according to
error number (from 00 to 17)
displayed.
• Air in gas supply;
• Gas supply is closed;
• Issue with the electric
supply of the burner
system;
• Burner system internal
failure;
• Air in gas supply;
• Gas supply is closed;
• Issue with the electric
supply of the burner
system;
• Burner system internal
failure;
Actions
Error during SPI-FLASH memory writing.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Communication impossible with FRAM memory.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Unknown FRAM memory device.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Software error: invalid data on FRAM memory.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Error during FRAM memory reading.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Error during FRAM memory writing.
• Switch OFF and ON the oven, if the problem
persists, call Service.
• Clean inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call Service.
Switch the oven OFF/ON;
If the error persists, manually clean the oven
cavity and call Service.
The oven can continue to work both in convec-
tion and ISG mode.
To recover full boiler functionality:
• Switch the oven OFF/ON.
• If the error occurs at the cycle start, call
Service.
• If the error occurs after 5 ignition attempts:
1. check the gas supply main valve is open;
2. reset the error and attempt new cycle;
3. if the error persists, switch OFF/ON the
oven and attempt new cycle again;
4. if the error persists, call Service
The oven will not operate until restoring the
burner functionality.
To recover the functionality:
• Switch the oven OFF/ON.
• If the error occurs at the cycle start, call
Service.
• If the error occurs after 5 ignition attempts:
1. check the gas supply main valve is open
2. reset the error and attempt new cycle
3. if the error persists, switch OFF/ON the
oven and attempt new cycle again;
4. if the error persists, call Service