Electrolux SkyLine PremiumS User Manual page 70

Anom- Type of
Description
aly anomaly
BSHt Warning Boiler SSR NTC
(NTC4) high
N°315
temperature
BSOt Stops Boiler SSR NTC over-
cooking temperature (NTC4)
N°314
cycle
butn Stops oven One or a combination
of the panel buttons
N°101
are permanently
blocked
Cdo Stops Cleaning drawer cap
cleaning absent
N°260
Warning in
cooking
CFbL Warning Cooling fan failure
N°294
CLdr Warning Cleaning drawer cap
missing before starting
a cooking or cleaning
cycle
CntC Stops Cavity SSR NTC fail-
cooking ure (NTC3)
N°310
CPUA Stops oven ACS microprocessor
does not communicate
N°203
CPUt Stops oven TC microprocessor
does not communicate
N°204
70
Possible causes
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine;
• Steam/Heat leakage in
the electronic
compartment;
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine,
• Steam/Heat leakage in
the electronic
compartment.
The panel has been acci-
dentally hit or damaged.
• The cap of the cleaning
drawer is not detected; it
is not possible to FINISH
a cooking or cleaning
cycle.
• Cooling fan motor over-
load due to dirt or
oxidation
• Other electrical/mechani-
cal issue
• The cap of the cleaning
drawer is not detected. It
is not possible to START
a cooking or cleaning
cycle.
• Connector failure;
• NTC sensor failure;
• ACU failure;
ACU failure.
ACU failure.
Actions
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call Service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform Service);
• If the error persists, call Service.
The oven can continue to work in recovery
mode: cooking cycles will not use the boiler.
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform Service);
• If the error persists, call Service.
Press all buttons to possibly unlock the wrong
one/ones. The permanent blocked buttons are
lighted during the error on display.
The oven can continue to cook but cleaning
cycle could not be performed until the drawer
cap will be in place;
• Screw correctly the cap on the cleaning
drawer in the front of the oven;
• If the error persists, rotate the cap 180° and
screw again. Call Service.
The oven will be operative until the electronic will
reach the critical temperature.
Call Service
• Screw correctly the cap on the cleaning
drawer in the front of the oven;
• If the error persists, rotate the cap 180° and
screw again. Call Service.
• Restart the oven;
• If the error persists, call Service.
• Restart the oven;
• If the error persists, call Service.
• Restart the oven;
• If the error persists, call Service.