Electrolux SkyLine PremiumS User Manual page 69

Anom- Type of
Description
aly anomaly
ACUP Stops oven Communication proto-
col error detected
N°205
ACSS Blocks ACS software version
oven; fatal (inside ACU board)
N°116
error incompatible with
present UI SW version
Blocks
ACUS ACU software version
oven; fatal
(main uC) incompati-
N°115
error ble with present UI SW
version
ASCH Warning Component compart-
ment temperature
N°292
warning
bAtt Warning Battery is low
N°110
BEtc Error, excessive time
Stops
cleaning on closing operation
N°243
during cleaning
BEto Error, excessive time
Stops
on opening operation
cleaning
N°242
during cleaning
BEtr Warning Boiler excessive tem-
perature raising time
N°224
Bhtc Warning Warning on excessive
time on closing
N°241
operation
Bhto Warning Warning on excessive
time on opening
N°240
operation
bntC Stops Boiler SSR NTC failure
boiler (NTC4)
N°313
BoLt Stops Boiler water loading
cycle (if the timeout
N°223
cycle
needs the
boiler)
Possible causes
The ACU has not been pro-
grammed correctly. The SD
Card on the UI may be
corrupted and not able to
perform the ACU update
with the software tempora-
rily loaded on it.
Wrong software upload
(example: after replacing
ACU board, the SW is not
uploaded)
Wrong software upload
(example: after replacing
ACU board, the SW is not
uploaded)
• Filter is dirty;
• Too high room
temperature.
Ageing
Mechanical or electrical
problem with vent valve.
Mechanical or electrical
problem with vent valve.
The oven has detected a
low performance in the
boiler.
• Flap (venting valve)
motoreducer or micro
switch failure.
• Obstruction at the vent-
ing valve inlet.
• Flap (venting valve)
motoreducer or micro
switch failure.
• Obstruction at the vent-
ing valve inlet.
Temperature sensor issue.
• Water supply (pressure/
quality of water).
• Electric insulation prob-
lem with water level
sensors.
Actions
• Switch the oven OFF/ON;
• If the error persists, call Service.
ACS software version (inside ACU board) incom-
patible with present UI SW version. Call service
ACU software version (main uC) incompatible
with present UI SW version.
Call Service.
• Check room temperature considering the
oven needs fresh air to cool electronic
compartment.
• Clean the filter;
• Allow oven to cool before cooking;
• If the problem persists, call Service.
Call Service to replace battery.
Call Service
Call Service
• It is possible to cook. Verify the cooking
results.
• If the warning persists call Service.
It is possible to continue using the oven. Cooking
results maybe different from usual.
• With the oven OFF and cold, check if any
obstruction at the ventilation chimney on the
top of the oven: remove the obstruction if any;
• If the problem persists, call Service.
It is possible to continue using the oven. Cooking
results maybe different from usual.
• With the oven OFF and cold, check if any
obstruction at the ventilation chimney on the
top of the oven: remove the obstruction if any;
• If the problem persists, call Service.
The oven has detected a problem with boiler
operation.
• Verify cooking results;
• If the problem persists, call Service.
• Check if the water supply is open;
• Check if the water pressure is not too low;
• Verify if the water filter is clogged. Clean it or
replace it;
• Mechanical problem with boiler operation. If
the problem persists call Service.
69