Display" Off Status; Machine" Off Status; Delay Start - Miele PDR 908 HP Operating And Installation Instructions

"Display" off status

The display switches off to save
energy; only the Start/Stop sensor
control flashes slowly. You can change
this setting.
Changing this setting leads to increased
energy consumption.
- Off
No switching off
- On (10 min), not curr.prog.
The display will remain on while the
program is running but will go out
10 minutes after the end of the
program.
- Logo (10 min), not curr.prog.
The display will remain on while the
program is running but the logo will
light up 10 minutes after the end of
the program.
- Factory default: On after 10 min.
The display goes out after
10 minutes.
- On (30 min), not curr.prog.
The display will remain on while the
program is running but will go out
30 minutes after the end of the
program.
- Logo (30 min), not curr.prog.
The display will remain on while the
program is running but the logo lights
up 30 minutes after the end of the
program.
- On after 30 min.
The display will go out after
30 minutes.
Supervisor level

"Machine" off status

In order to save energy, the tumble
dryer will switch off automatically after
the end of the program or if no further
selection is made. You can change
this setting.
Changing this setting leads to increased
energy consumption.
- No switch off
- Factory default: Switch off after
15 minutes
- Switch off after 20 minutes
- Switch off after 30 minutes

Delay start

The delay start (timer) can be
activated or deactivated.
- Factory default: Off
- On
SmartStart
The function to delay start changes
when the SmartGrid setting is
activated. The period of time in which
the drying program will start
automatically is then shown in the
display: SmartStart by, SmartStart in,
or SmartFinish by.
The program is started via an external
signal.
The time period can be defined up to
24 hours. During this period, the tumble
dryer waits for an external signal. If no
signal is sent during the defined period,
the tumble dryer starts the drying
program once the defined period of
time has elapsed.
89