Electrical Connection - Miele PDR 908 HP Operating And Installation Instructions

Installation and connection

Electrical connection

This description applies to tumble
dryers both with and without an
electrical plug.
The following applies to tumble dryers
with an electrical plug:
- This tumble dryer is supplied with a
power cord and NEMA L6-30P plug
ready for connection.
- The plug must be easily accessible
after installation so that the machine
can be disconnected from the power
supply if necessary.

Damage caused by incorrect
supply voltage.
The data plate indicates the nominal
power consumption and the
appropriate fuse rating.
Compare the specifications on the
data plate with those of the electrical
supply and make sure that they
match.
The tumble dryer may only be
connected to a permanent electrical
system that conforms to the national
and local codes and regulations.
The tumble dryer should never be
connected by an extension cord, e.g.
power strips, to avoid the risk of fire.
If the machine is hard-wired, a dual
circuit breaker must be provided on
site. When switched off, there must be
an all-pole contact gap of at least 3 mm
in the isolator switch (including circuit
breakers, breakers, and relays
according to IEC/EN 60947). This
connection process must be performed
by a qualified electrician.
84
The plug connector or isolator switch
should be easily accessible at all times.

Risk of electric shock.
If the tumble dryer is disconnected
from the electrical supply, protective
measures must be taken to ensure
that the point of disconnection
cannot accidentally be switched on
again.
Make sure the isolator is lockable or
the point of disconnection is
monitored at all times.
New connections, modifications to the
system, or servicing of the ground
conductor, including determining the
correct fuse rating, must be carried out
by a qualified electrician, as they are
familiar with the pertinent regulations
and the specific requirements of the
electric utility company.
The tumble dryer must not be
connected to devices such as timers
which would switch it off
automatically.