Supervisor level
The date can be shown starting with the day, month or year.
Date
-
The date is set.
Volume
The volume for various sounds can be changed.
The volume can be changed for the following tones:
-
Finish tone
The finish tone signals the end of the drying programme.
Keypad tone
-
-
Welcome tone
Fault alarm
-
The fault tone signals a fault and can be switched off. The volume of the fault tone can-
not be adjusted.
Res. moisture display
In addition to displaying the drying level, the residual moisture can also be indicated as a
percentage.
Without % value
- Factory default:
-
With % value
Visibility parameters
Various parameters are offered/displayed when a programme is selected. You can decide
which parameters should not be displayed. These parameters can then not be edited dur-
ing programme selection.
Residual moisture
-
Duration
-
Low temperature
-
-
Anti-crease
Load size
-
Drying temperature
-
Display off status
The display switches off to save energy; only the Start/Stop sensor flashes slowly. You
can change this setting.
Changing this setting leads to increased energy consumption.
Off
-
No switching off
-
On (10 min.) Not curr.prog.
The display will remain on during the programme sequence but will go out 10 minutes
after the end of the programme.
46