Product Description; Intended Use; Roller Coating; Initial Commissioning - Bosch BSA 7 Series Product Description

Roller sets truck with or without lifting device
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19
3.

Product description

3.1

Intended use

The roller sets described in this product description
may be used only with the brake tester BSA 7xxx / 8xxx.
The field of application is described in the original
operating instructions for this product.
Any application beyond the scope of these
specifications does not constitute the intended
purpose and could result in serious injuries or damage.
The manufacturer cannot accept any liability for injury
or damage arising from such usage.
3.2

Roller coating

i
All rollers are available with a plastic or corundum
coating or spikes.
3.3

Initial commissioning

!
Initial commissioning to be carried out only by
authorized service technicians.
!
The specifications given in the planning folder are
minimum requirements designed to ensure correct
installation of the BSA 7xxx / 8xxx. Any particular
local legislation, guidelines and standards must
be observed with regard to the specifications.
Beissbarth GmbH does not accept any liability
for damage arising from non-observance of local
regulations.
i
The installation conditions must be satisfied before
the start of erection work by a service engineer.
Further information can be found in the planning
folder.
3.4

Configuration

!
Only Service personnel are authorized to make all
the necessary configuration settings and calibrate
the sensors.
Beissbarth GmbH
Product description | BSA 7xxx / 8xxx | 21
3.5

Special accessories

The following components are available as special
accessories for the brake tester:
Component
Roller cover plate BSA 7xxx
Roller cover plate BSA 8xxx
SDL 515 Quick side slip tester
Edge protection frame for SDL 515
Tab. 1:
Overview of special accessories
3.6

Operation

Operation of the BSA 7xxx / 8xxx is described in the
associated original operating instructions.
Remaining hazard warning!
The possibility of remaining hazards
cannot be excluded when using the
BSA 7xxx / 8xxx.
Heed the safety instructions in the
enclosed user information.
Wear protective clothing and equipment.
en
Order number
1 691 882 086
1 691 812 136
1 691 841 007
1 691 842 001
|
1 691 806 123
2017-06-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bsa 8 series

Table of Contents