Panasonic LP-V Series Operation And Maintenance Manual page 176

Description
6 X/Y Offset :
Shifts the object to X/Y direction. This coordinate is applied to the origin of the base object.
Setting Range
7 Count up / down at each step :
Check this box to validate the counter updating at each marking of Step & Repeat.
Reference
• Counter marking is impossible unless the functional character for counter has been input in the character string for
marking.
• In case the counter is included in the marking character and the "Count up/down at each step" is not selected, the all
counter values are the same in one Step & Repeat marking as shown in the figure below.
1 1 1
1 1 1
1 1
1
8 Count "Mark OFF" :
When the Step & Repeat counter is used and set the mark off in the specified pattern, select here whether the
counter value of the marking off part is counted or skipped.
Refer to "Step & Repeat Fine-Adjustment" (P.178).
Yes : Skips counter value on the column/row which "Mark OFF".
(ex) Step-Repeat with 3 rows × 3 columns
No : Not skip counter value on the column/row which "Mark OFF".
(ex) Step-Repeat with 3 rows × 3 columns
176
-45.000 to +45.000 mm (LP-V10)
-55.000 to +55.000 mm (LP-430 / LP-420 / LP-410)
-80.000 to +80.000 mm (LP-435 / LP-425 / LP-V15)
-27.500 to +27.500 mm (LP-431 / LP-421 / LP-411 / LP-W052)
2 2 2
2 2 2
2 2
2
Marking OFF: marking on the 2nd row of 2nd line
Direction: Hori.
Starting Position: Upper L
Marking OFF: marking on the 2nd row of 2nd line
Direction: Hori.
Starting Position: Upper L
3 3 3
3 3 3
3 3
3
ME-LP400V-OP-6
4 4 4
4 4 4
4 4
4
1 2
4
7 8
1 2
4
6 7
3
6
9
3
5
8