Panasonic LP-V Series Operation And Maintenance Manual page 120

2. Set the status of the laser marker into ready for receiving for trigger.
1.
Press the laser pumping switch on the controller.
The laser pumping switch will be flashing in white. When the switch
is changed from flashing to lightning up, the laser marker is ready for
radiation.
(Flashing time: approx. 20 sec.)
2.
Set marking mode to [RUN].
3.
Press [START].
The marking is started by inputting trigger.
Reference
• Set the marking mode to "RUN" and press START. Then the internal shutter is opened and the laser marker is ready for
receiving the trigger.
• For changing the status of the laser marker into ready for receiving trigger, set the marking mode to "REMOTE", other
than setting into "RUN" mode, and control the laser marker from the external. Refer to "External Control Manual" for
details.
120
ME-LP400V-OP-6
Flashing to
lightning