4-6-3 Test Marking
Test marking is a marking method of radiating laser by the button operations on the setting screen.
1.
Press the laser pumping switch on the controller.
2.
Set the marking mode into [TEST].
3.
The marking is started by pressing [START].
The laser marker is performed the following procedure.
Reference
• The counter does not activate at test marking.
WARNING
138
Press [START] for test marking.
Internal Shutter: Open
Marking
Internal Shutter: Close
• Once starting the test marking, the laser radiation cannot be stopped till
the marking is finished. If the operator needs to stop the laser radiation
immediately, press the emergency stop switch.
ME-LP400V-OP-6