Figure 88: Device Window - GE RPV311 Technical Manual

Chapter 13 – RPV Manager
1.1.1.3 TRANSMISSION LINES (AUTOMATIC FAULT LOCATION)
RPV311-TM-EN-7

Figure 88: Device window

There are two parameters to be configured by the user:
Enable Auto COMTRADE Download: When enabled, the unit will be part of the Auto
Polling process, where records not yet saved are automatically downloaded.
Enable Auto Refreshing: When enabled, the unit will be part of the process of Auto
Refresh, where the equipment state will be updated automatically during the
process.
The user can change the equipment host address, and enable or disable the "Enable
Auto COMTRADE Download" and "Enable Auto Refreshing". At the end of the editing,
the software automatically communicates with the equipment in order to upgrade
the name and location information.
If the equipment is associated with any transmission, a message will be shown to the
user at the beginning of the Edit.
After the closing the 'Device' window, the equipment updates are registered.
The transmission line window configures the parameters necessary to execute the
Traveling Wave Fault Location algorithm on the TW high acquisition frequency
records.
On this menu the user can view the list of the registered lines, add, edit, or remove
any transmission line.
RPV311
191