Setting The Stock Sensor; Enabling A Sensor; Over/Back - Avery Dennison Monarch Sierra Sport4 9493 Administrator's Manual

Setting the Stock Sensor

Use this option to set the sensor for die cut, black mark, or non-indexed (continuous) supplies.
The default is black mark. Select the correct sensor for the supply type you are using.
Select the:
♦ Die-cut sensor for die cut supplies (labels on a liner with gaps between the labels).
♦ Black mark sensor for black mark supplies (supplies with rectangular marks on the back side
of the liner or on the supply).
♦ Non-indexed sensor for non-indexed (continuous) supplies without a black mark or
perforations.
Note: If you have die cut supplies with black marks, select the black mark sensor.

Enabling a sensor

1. From the Printer Setup menu, select Stock Sensor.
A checkmark indicates the current setting.
2. Press D or U until you see the sensor you need.
3. Press e to save the setting or press X to cancel without saving changes. You return to the
Printer Setup menu.
O v e r / B a c k
You must enable the Over/Back option to use overfeed and backfeed.
The default is disabled. When this option is enabled, use the Overfeed and Backfeed menu
options to set the distance for each option.
1. From the Printer Setup menu, press D or U until Over/Back is highlighted.
2. Press e to enable or disable overfeed and backfeed.
A checkmark appears when overfeed and backfeed are enabled.
Refer to the Packet Reference manual for more information about overfeed and backfeed.
Setting Up the Printer 2-5