MaxTech XT4888 User Manual

14 inch color monitor

Advertisement

Quick Links

XT4888
14 INCH

COLOR MONITOR

USER'S
MANUAL
Features:
• 1024 x 768, Non-Interlaced
• .28 mm Dot Pitch
• 72 Hz Refresh Rate (VGA/SVGA)
• Power Saving Operation (VESA DPMS)
• Non-Glare Screen
• Full Screen Display
• Easy Access Front Controls
• Unlimited Palette of Colors
Part #MAN075 Rev 1.0
M1448

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XT4888 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MaxTech XT4888

  • Page 1: Color Monitor

    XT4888 14 INCH COLOR MONITOR USER'S MANUAL Features: • 1024 x 768, Non-Interlaced • .28 mm Dot Pitch • 72 Hz Refresh Rate (VGA/SVGA) • Power Saving Operation (VESA DPMS) • Non-Glare Screen • Full Screen Display • Easy Access Front Controls •...
  • Page 2: Table Of Contents

    Table of Contents Section 1 - General Information ...2 Section 2 - Installation ... 3 Section 3 - Monitor Controls and LEDs ... 4 Section 4 - Troubleshooting ...5 Appendix A - Specifications ...5 Appendix B - Video Cable Pinout ... 6 Appendix C - Two Year Warranty ...
  • Page 3: Section 1 - General Information

    Section 1 - General Information Congratulations on purchasing a MaxTech 14-inch Color Monitor. The monitor has one of the finest CRTs available in the industry, providing a full range of video display resolutions and complies with the MPR-I standard to reduce electromagnetic emissions.
  • Page 4: Section 2 - Installation

    are re-enabled the monitor returns to normal operation. Section 2 - Installation Attaching the Base • Carefully place the monitor on its side or top. • Insert the hooks on the swivel base into the slots in the bottom of the monitor.
  • Page 5: Section 3 - Monitor Controls And Leds

    Section 3 - Monitor Controls and LEDs Figure 3-1 Controls and LEDs 1. Power Indicator: LEDs A, B, and C indicate the state of the Monitor. • LEDs A, B and C On – Normal operations. • LEDs B and C On – DPMS (Display Power Management Signaling) “SUSPEND”...
  • Page 6: Section 4 - Troubleshooting

    Section 4 - Troubleshooting No picture, power indicators A, B, C off • Check AC cord is plugged into outlet and monitor. • Turn on the power switch. No picture, power indicators A, B, C on. • Check that video cable is connected completely. •...
  • Page 7: Appendix B - Video Cable Pinout

    Pincushion distortion High voltage regulation Low radiation* Front controls Power saving Input voltage Power consumption 85W maximum Operating Environment Connector Dimensions *Low radiation monitors only. Specifications subject to change without notice. Appendix B - Video Cable Pinout Figure D - Pin Layout and Pin Assignment Chart...
  • Page 8: Appendix C - Two Year Warranty

    Except as specified below, this warranty covers all defects in material or workmanship in this product. The following are not covered by the warranty: 1. Any product which is not distributed in North America by MaxTech or which is not purchased in North America from an authorized MaxTech Dealer.
  • Page 9: Appendix D - Notices

    damages based upon inconvenience, loss of use of the product, loss of time, commercial loss; or 2. Any other damages, whether incidental, consequential or otherwise. Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequen- tial damages, so the above limitations and exclusions may not apply to you.
  • Page 10 All registered trademarks are the property of their respective owners. Copyright © 1996 MaxTech. All rights reserved. No reproduction of this document in any form is allowed without written permission from MaxTech.

Table of Contents