Battery Charging - VTech CS6409 User Manual

Getting started

Battery charging

Once you have installed the battery, the screen indicates the
battery status (see the table below).
• For best performance, keep the handset in the telephone base
or charger when not in use.
• The battery is fully charged after 10 hours of continuous
charging.
• If you place the handset in the telephone base or the charger
without plugging in the battery, the screen displays NO BATTERY.
Battery indicators
The screen is blank,
or shows
PLACE IN CHARGER
and flashes.
The screen shows
LOW BATTERY and
flashes.
The screen shows
HANDSET X.
When the battery is fully charged, you can expect the following
performance:
Operation
While in handset use (talking*)
While in speakerphone mode (talking*)
While not in use (standby**)
*Operating times vary depending on your actual use and the age of the battery.
**Handset is not charging or in use.
After you install your telephone or power returns
following a power outage, the handset will
prompt you to set the date and time. To skip
setting the date and time, press
Battery status
Battery has no
charge or very
little charge. The
handset cannot
be used.
Battery has
enough charge to
be used for a
short time.
Battery is charged. To keep the battery
/CANCEL.
OFF
3
Action
Charge without
interruption (at least
30 minutes).
Charge without
interruption (at least
30 minutes).
charged, place it in the
telephone base or charger
when not in use.
Operating time
Up to seven hours
Up to four hours
Up to five days
SET DATE
--/--/--