Battery Charging; Add And Register A Handset; Deregister Handsets - VTech LS6005 User Manual

Battery charging

Once you have installed the battery, the screen indicates the battery status (see
the table below). For best performance, keep the handset in the telephone base
or charger when not in use. The battery is fully charged after  hours of
continuous charging.
Battery indicators
The screen is blank, or
displays Put in charger
and flashes.
The screen displays
Low battery and flashes.
The screen displays
HANDSET X.

Add and register a handset

You can add new handsets (LS6005/LS6005-13/LS6005-15/LS6005-16/LS6005-17,
purchased separately) to your telephone system. Each handset must be registered
with the telephone base before use. Additional handsets registered to the telephone
system are assigned numbers in the sequential order.
When first purchased and properly charged, each expansion handset alternately
displays To register HS... and ...see manual. The new handset should be charged
without interruption for at least 30 minutes before registering it to the telephone base.
To register a handset:
. At the bottom of the telephone base, press and hold
/FIND HANDSET for about four seconds until it
shows Registering...
. On the cordless handset, press
Registering... Both the telephone base and cordless
handset show Registered and you hear a beep when
the registration process completes. The registration
process takes about 60 seconds to complete.

Deregister handsets

If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all handsets and then deregister each
handset individually.
To deregister all handsets:
Press and hold /FIND HANDSET at the bottom of the telephone base for
.
about 0 seconds until the telephone base shows Registering... then
De-register?
. Immediately press /FIND HANDSET again. You hear a confirmation tone.
All handsets alternately show To register HS... and ...see manual. The
3.
deregistration process takes about 0 seconds to complete.
To register the handset(s) to the telephone base again, follow the registration
instructions above.
Battery status
The battery has no or very
little charge. The handset
cannot be used.
The battery has enough
charge to be used for a
short time.
The battery is charged.
then it shows
3
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone base
or charger when not in use.