Troubleshooting - Olympus DS-2500 Instructions Manual

Troubleshooting

Symptom Probable cause
The batteries are not loaded properly.
Nothing appears on
The batteries are dead.
the display
The recorder is in power off mode.
The recorder is in power off mode.
Won't start
The batteries are dead.
The card does not have enough memory.
The card is unformatted.
Unable to record
The maximum number of files has been
reached.
The SD card is locked.
The earphone is connected.
No playback tone
heard
The volume level is set to [00].
The file is locked.
Unable to erase
The SD card is locked.
The recorder was shaken during recording.
Noise heard during
The recorder was placed near a cell phone or
playback
fluorescent lamp while recording or during
playback.
Recording level too
The microphone sensitivity is too low.
low
Action
Verify polarity is correct ( ☞ P.12).
Charge the batteries or replace with new
batteries (☞ P.12, P.14, P.15).
Turn the power on ( ☞ P.17).
Turn the power on ( ☞ P.17).
Charge the batteries or replace with new
batteries (☞ P.12, P.14, P.15).
Erase unnecessary files or insert another card
(☞ P.19, P.32).
Format the card (☞ P.50).
Change to any other folder (☞ P.36).
Unlock the SD card lock.
Unplug the earphones to use the internal
speaker.
Adjust the volume level ( ☞ P.30).
Unlock the file from the file menu (☞ P.42).
Unlock the SD card lock.
———
Move the recorder.
Set the microphone sensitivity to Conference
mode and try again (☞ P.27).
6
EN
61