Table of Contents
Advertisement
Removing the Top
Cover
Installing the PathBuilder S21x Switch Hardware
Refer to Figure 2-5 when removing the top cover and front panel and follow these
steps:
Step
1
Open front panel door by using a downward motion to pull it toward
you and off.
2
Insert a flat-head screwdriver in the slot above each of the six snap
hinges on the sides of the unit and push downward. The hinges snap
out toward you.
3
Repeat Steps 1 and 2 for the remaining hinges.
4
Lift off the top cover.
Open and remove front
1
panel by unsnapping the
panel from its tabs.
Figure 2-5. Removing Top Cover and Front Panel on
PathBuilder S21x Switch
Installing or Removing the Lithium Battery
Action
3
®
4
Repeat for all six hinges
Release hinges
on each side.
2
Insert a flat-head screwdriver in the
slot above each of the six snap
hinges on the sides of the unit and
push downward. The hinges snap
out toward you.
2-13
Advertisement
Table of Contents
