Digital Audio Connector (4-1 Pin Spdif_Out) - Asus A68HM-F Web Manual

4. Serial ATA 6.0 Gb/s connectors (7-pin SATA6G 1~4)
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, or RAID 10 configuration through the onboard controller.
A68HM-F
A68HM-F SATA 6.0Gb/s connectors
• These connectors are set to AHCI mode by default. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID].
• You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI].
5.

Digital audio connector (4-1 pin SPDIF_OUT)

This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port.
A68HM-F
A68HM-F Digital audio connector
The S/PDIF module is purchased separately.
ASUS A68HM-F
SATA6G_1 SATA6G_2
XP Service Pack 3 or later version before using Serial
®
XP SP3 or later version.
®
SPDIF_OUT
SATA6G_4
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXN4
RSATA_RXP4
GND
SATA6G_3
1-17